Gracias por sus respuestas!
Perdón por saltarme la presentación, ya lo hice.
Hace poco adquirí unos parlantes Monitor Audio MR6 columnas. Según las características de los parlantes tengo susto de dañarlos con el amp que tengo... Me gustaría saber si los puedo dañar y que otro amplificador me recomiendan, siempre es bueno ir mejorando en equipos... Pero antes hay que ahorrar un poquito y ver si usar un tiempo los parlantes con el diatone no los dañará. -Características de los parlantes Monitor Audio MR6:
Frequency Response
33 Hz — 30 kHz
Sensitivity (1W@1M)
90 dB
Nominal Impedance
6 ohms
Power Handling (RMS)
150 W
Recommended Amplifier Requirements
40 — 150 W
Bass Alignment
Bass reflex. Ported front and rear.
Drive Unit Complement
2 x 6.5" MMP II bass driver 1 x 6.5" MMP II mid-range 1 x 1" Gold Dome C-CAM Tweeter
External Dimensions (Including Plinth (H x W x D))
970 x 200 x 300 mm (383/16 x 77/8 x 1113/16 inch)
Weight (each)
17.2 kg (37.8 lbs)
- Características del amp diatone u480:
Form
Integrated Amplifier
Circuit system
Power-amplifier part: 2 steps of differential whole page direct connection pure complimentary OCL
Equalizer amplifier part: Positive/negative 2 power source, high proof-pressure IC
Continuation output (20Hz - 20kHz)
25W+25W (8ohms)
THD
(20Hz - 20kHz, 8ohms)
At the time of an Output power: 0.1%
At the time of 13W output: 0.05%
At the time of 1W output: 0.05%
Output bandwidth (IHF 0.1% distortion)
10Hz - 40kHz
Dumping factor
40 (1kHz, 8ohms)
Conformity load impedance
4ohm-16ohm
Input sensitivity/impedance
Phono: 2.5mV/50kohm
Tuner, AUX, Play1, 2:150mV/50kohm
Mic: 2mV/10kohm
An Output voltage/impedance
Rec1, 2:150mV/600 ohms
Headphone: 340mV/eight ohms
Frequency response
Phono(RIAA deflection): 20Hz-20kHz±0.5dB
Tuner, AUX, and Play:10Hz-60kHz+0 -1 dB
Phono maximum permissible input
200mV (distorted [ 0.1% ] 1kHz)
Tone control
Bass: ±8dB (100Hz)
Treble: ±8dB (10kHz)
Loudness control
+6dB(100Hz)
Volume 30dB o'clock: +3dB (10kHz)
S/N ratio (IHF, A network)
Input short-circuit
Phono:74dB
Tuner, AUX, Play: 100dB
The semiconductor used
IC: Two pieces
Transistor: 26 pieces
Diode: 19 pieces
Power source
AC100V 50Hz/60Hz
Power consumption
At the time of the Electrical Appliance and Material Control Law output : 63W
At the time of an Output power: 110W
The power-source side fuse capacity
AC125V, 3A
AC outlet
Two lines (total 1A)
Dimensions
Width 480x height 139x depth of 324mm
Weight
7kg
Quedo muy atento y gracias de antemano por tanto!
Saludos!